Helps with discovery and setup of physics solver settings, in a specific
project settings section for both 2D and 3D.
Other changes for cleanup:
-Removed unused space parameters in 3D
SPACE_PARAM_BODY_ANGULAR_VELOCITY_DAMP_RATIO
SPACE_PARAM_CONSTRAINT_DEFAULT_BIAS
-Added custom solver bias for Shape3D (same as Shape2D)
-Improved documentation for solver settings
In scenes that have little to no overdraw, disabling the depth prepass
can give a small performance boost. Nonetheless, in most other scenarios,
the depth prepass should be left enabled as it improves performance
significantly.
Settings that aren't within a subsection are difficult to reach when
other settings do have a subsection.
This also adds documentation for the project setting.
Only Vulkan is fully implemented for now, so OpenGL isn't available
in the project manager yet.
This also makes the rendering driver checks use lowercase names
everywhere for consistency.
- Rename OpenGL to GLES3 in the source code per community feedback.
- The renderer is still exposed as "OpenGL 3" to the user.
- Hide renderer selection dropdown until OpenGL support is more mature.
- The renderer can still be changed in the Project Settings or using
the `--rendering-driver opengl` command line argument.
- Remove commented out exporter code.
- Remove some OpenGL/DisplayServer-related debugging prints.
This can be used to improve 3D shadow rendering quality at little
performance cost. Unlike the existing Hard setting which is limited
to variable shadow blur only, it works with both fixed blur and
variable blur.
This allows for finer control over 3D rendering resolution.
Supersampling can also be performed by setting a 3D rendering
resolution above 1.0, which is useful for offline rendering or
for very high-end GPUs.
This can be used as a shorthand for:
if OS.is_stdout_verbose():
print("...")
Unlike `print_debug()`, this works in release builds too and can
be toggled off in debug builds.
Browsers doesn't really like forcing the mix rate, e.g. Firefox does not
allow input (microphone) if the mix rate is not the default one, Chrom*
will exhibit worse performances, etc.
If enabled, key/touch/joystick events will be flushed just before every idle and physics frame.
Enabling this can greatly improve the responsiveness to input, specially in devices that need to run multiple physics frames per each idle frame, because of not being powerful enough to run at the target frame rate.
This will only work for platforms using input buffering (regardless event accumulation). Currenly, only Android does so, but could be implemented for iOS in an upcoming PR.
- Back to 1-based layer names to make it clearer in editor UI
- Layer bit accessors are renamed to layer value and 1-based too
- Uniform errors and documentation in render and physics
- Fix a few remaining collision_layer used in place of collision_mask
The project setting wasn't being used anywhere.
This also tweaks the property hints to denote that these properties
are only effective after a restart.
* Only apply final actions to attachments used in the last pass.
* Fixes to draw list final action (was using continue instead of read/drop).
* Profiling regions inside draw lists now properly throw errors.
* Ability to enable gpu profile printing from project settings. (used to debug).
This makes it clearer that this property is only about physics FPS,
not rendering FPS.
The `physics_fps` project setting was also renamed to
`physics_ticks_per_second` for consistency.
